Siemens FLENDER K SH Series - Separate Oil-Supply System Installation; Electric Connections; Wiring for Heating Systems; Wiring for Temperature Monitoring

69 / 109
BA 5846 en 05/2015
6.11 Gear unit with separate oilsupply system
• Remove the plugs out of the suction and delivery lines prior to connecting the system.
• Fit the system to the gear unit or install it separately, in accordance with the drawings supplied in the
gearunit documentation.
• The pipework must not be overstressed during the fitting procedure.
Note
Consult operating instructions for oilsupply system.
6.12 Electric connections
Wire up the monitoring devices and electrical components on the gear unit in accordance with the terminal
diagram.
Note
Electrical lines and the motors and monitoring equipment must be connected electrically in accordance
with terminal diagrams, lists of equipment and general regulations.
Electrical equipment for regulation and control must be wired in accordance with the equipment
suppliers’ instructions and Directive 94/9/EC.
WARNING
Risk of injury through electric shock
Risk of injury through electric shock when connecting up electrical components.
Before connecting up equipment, ensure that they are voltagefree.
6.13 Gear unit with heating
• Wire the heating system electrically.
• Wire the oillevel monitors for the heating rods (in EXversion) electrically.
6.14 Gear unit with oiltemperature monitoring system
• Wire the temperature monitor electrically.
6.15 Oillevel monitoring system
• Wire the oillevel limit switch electrically.
6.16 Bearingmonitoring system
• The bearingmonitoring device must be fitted by the customer.
6.17 General notes on addon components
Note
For operating and servicing the components described in section 5, the corresponding operating
instructions and the specifications in section 6 must be observed.
For technical data and control information, refer to the data sheet and/or the orderspecific list of
equipment.