Siemens FLENDER K SH Series - Oil Quantities

76 / 109
BA 5846 en 05/2015
• Check the oil level in the gearunit housing.
Note
The oil must come up to the middle of the oilsight glass, to the middle between the MIN and MAX marks
on the oillevel indicator or to the middle between the MIN and MAX marks on the dipstick.
CAUTION
Risk of injury through chemical substances
The oil must not come into contact with the skin (e.g. the operator’s hands).
The safety notes on the data sheets for the oil used must be observed.
Remove any oil spillage immediately with a binding agent.
Observe manufacturer’s instructions for handling lubricants and binding agents.
Wear suitable protective clothing.
• Place the inspection and/or assembly cover with the seal on the housing.
• Screw in the fastening screws of the cover and tighten them to the specified tightening torque
(see item 6.19).
• Screw in the air filter with the reducing screw or the wetair filter again.
NOTICE
Material damage
Risk of damage to the wetair filter.
Prior to using the wetair filter, 2 of the 8 sealed bores at the underside of the wetair filter must be opened.
7.1.3.1 Oil quantities
Table 13: Approximate values for required oil quantities in mounting position in gear units of
sizes 15 to 24
Type
Oil quantity (approximate value)
in litres for sizes 15 to 24
15 16 17 18 19 20 21 22 23 24
K3SH, K3SM, K3VH, K3HH ,K3KH, K3DH
150 175 210 240 285 360 410 520
1) 1)
K3HM, K3KM, K3DM
150 175 210 240 285 360 410 520
1) 1)
K4SH, K4SM, K4VH, K4HH ,K4KH, K4DH
165 200 245 285 320 420 465 540
1) 1)
K4HM, K4KM, K4DM
165 200 245 285 320 420 465 540
1) 1)
1)
on request