107 / 109
BA 5846 en 05/2015
12. Declarations
12.1 Declaration of incorporation
Declaration of incorporation
in accordance with Directive 2006/42/EC, Annex II 1 B
The manufacturer, Siemens AG, 46395 Bocholt, Germany, declares with regard to the partly completed
machinery
Crane gear unit
K.SH, K.SM, K.VH, K.HH, K.KH,
K.DH, K.HM, K.KM, K.DM
Sizes 15 to 24
and sizes 115 to 124
for use as lifting and luffing gear unit:
– The special technical documents described in Annex VII B have been prepared.
– The following basic health and safety requirements set out in Directive 2006/42/EC, Annex I, are applied
and are satisfied:
1.1, 1.1.2, 1.1.3, 1.1.5, 1.2.4.4, 1.2.6, 1.3.1, 1.3.2, 1.3.3, 1.3.4, 1.3.6, 1.3.7, 1.3.8, 1.3.8.1, 1.4.1, 1.4.2.1,
1.5.1, 1.5.2, 1.5.4, 1.5.5, 1.5.6, 1.5.7, 1.5.8, 1.5.9, 1.5.10, 1.5.11, 1.5.13, 1.5.15, 1.6.1, 1.7.1, 1.7.1.1, 1.7.4,
1.7.4.1, 1.7.4.2, 1.7.4.3
– The partly completed machinery must not be put into service until it has been established that the
machinery into which the partly completed machinery is to be incorporated has been declared to be in
conformity with the provisions of Directive 2006/42/EC, as appropriate.
– The partly completed machinery is in conformity with the provisions of the Directive(s):
94/9/EC
– The manufacturer undertakes, in response to a reasoned request by national authorities, to transmit in
electronic form relevant information about the partly completed machinery.
– The person authorised to compile the relevant technical documentation is:
Mark Zundel (PD MD AP EMEA VOE OE)
Voerde, 2015‐05‐18
Mark Zundel
(PD MD AP EMEA VOE OE)
Voerde, 2015‐05‐18
Dr. Bernhard Hoffmann
(PD MD AP)
To Next Page
Loading...
