Siemens FLENDER K SH Series - Page 6

6 / 109
BA 5846 en 05/2015
5.9 Couplings, clutches 37.................................................................
5.9.1 Shrink disk 37.........................................................................
5.10 Heating 38............................................................................
5.11 Heating element in "Ex"version 39.......................................................
5.11.1 Oillevel monitoring of the heating elements 39.............................................
5.12 Indication of oil level 39.................................................................
5.13 Oiltemperature monitoring system 40....................................................
5.14 Oillevel monitoring system 41...........................................................
5.15 Bearingmonitoring system 41...........................................................
5.15.1 Bearing monitoring by Pt 100 resistance thermometer 41....................................
5.15.2 Bearing monitoring by shockpulse transducer 42..........................................
5.15.3 Bearing monitoring by accelerometer 42..................................................
5.15.4 Gear unit with torquelimiting backstop 43.................................................
5.16 Changeover 44........................................................................
6. Fitting 45.............................................................
6.1 General information on fitting 45.........................................................
6.2 Unpacking 46.........................................................................
6.3 Fitting the gear unit 47..................................................................
6.3.1 Fitting the gearunit on a housing base 47.................................................
6.3.1.1 Foundation 47.........................................................................
6.3.1.2 Foundation for torque arm 47............................................................
6.3.2 Description of fitting work 48.............................................................
6.3.2.1 Alignment 49..........................................................................
6.3.2.2 Fitting on a foundation frame 51..........................................................
6.4 Shaftmounted gear unit with solid shaft 51................................................
6.5 Fitting a shaftmounted gear unit with hollow shaft and parallel keyway 52......................
6.5.1 Preparatory work 52....................................................................
6.5.2 Fitting 52.............................................................................
6.5.2.1 Pulling on 53..........................................................................
6.5.2.2 Axial securing 53......................................................................
6.5.3 Demounting 54........................................................................
6.6 Shaftmounted gear unit with hollow shaft and splines to standard "DIN 5480" 56...............
6.6.1 Preparatory work 56....................................................................
6.6.2 Fitting 56.............................................................................
6.6.2.1 Fitting with integrated DU bush 57........................................................
6.6.2.2 Fitting with loose DU bush 58............................................................
6.6.2.3 Axial securing 58......................................................................
6.6.3 Demounting 58........................................................................
6.7 Shaftmounted gear unit with hollow shaft and shrink disk 61.................................
6.7.1 Preparatory work 61....................................................................
6.7.2 Fitting 61.............................................................................
6.7.2.1 Fitting with integrated DU bush 62........................................................
6.7.2.2 Fitting with loose DU bush 63............................................................
6.7.2.3 Axial securing 63......................................................................
6.7.3 Shrink disk 63.........................................................................
6.7.4 Demounting 63........................................................................