Siemens FLENDER K SH Series - Page 8

8 / 109
BA 5846 en 05/2015
10. Maintenance and repair 96............................................
10.1 General notes on maintenance 96........................................................
10.1.1 General service lives of oils 98...........................................................
10.2 Maintenance and repair work 98.........................................................
10.2.1 Examine water content of oil, conduct oil analyses 98.......................................
10.2.2 Change oil 99.........................................................................
10.2.3 Replace the wetair filter 100.............................................................
10.2.4 Clean the air filter 101...................................................................
10.2.5 Check friction linings of torquelimiting backstop 101.........................................
10.2.6 Clean the fan and gear unit 103...........................................................
10.2.7 Recharge grease to splines on output shaft / spacer 103......................................
10.2.8 Repack grease in the Taconite seals 103...................................................
10.2.9 Check cooling coil 104...................................................................
10.2.10 Check hose lines 104....................................................................
10.2.11 Top up oil 105..........................................................................
10.2.12 Check tightness of fastening bolts 105.....................................................
10.3 Final work 105..........................................................................
10.4 General inspection of the gear unit 105.....................................................
10.5 Lubricants 105.........................................................................
11. Spare parts, customer service 106......................................
11.1 Stocking spare parts 106.................................................................
11.2 Addresses for ordering spare parts and customer service 106.................................
12. Declarations 107.......................................................
12.1 Declaration of incorporation 107..........................................................
12.2 EC declaration of conformity 108..........................................................