Equipment settings
14
U24802-J-Z146-2-7600 RM400 C Models 161
Dokuschablonen Version 3.2 vom 25.10.93 © Siemens Nixdorf Informationssysteme AG 1993
Druck vom 12. 04.1999 16:17.37 Pfad: H:\Christoph\Manuale\PDF\RM\RM400C Betriebsanleitung\englisch\rm400.k14
14.1 Default settings for screens and printers
You can connect a whole range of different terminals and printers to your system.
For more detailed information on these peripheral devices, see the relevant
operating manuals. For information on terminals and printers suitable for your
system, contact your local SNI office.
Because terminals and printers are supplied with default settings, you may have to
adapt them to the interface of your system unit.
14.1.1 Configuring the V.24 interfaces
The designations which are marked with * (asterisk) in the tables in this
section are the same as those used in the Config interface. For more infor-
mation on configuring the interfaces, refer to the manual “System Admin-
istration and Hardware Configuration Using the SYSADM User Interface”
and the manual “Hardware Configuration with Config under
SINIX/windows”.
Direct serial interfaces
The two direct serial interfaces
can be addressed with the following special files
(Attachment device column):
Interface Attachment
type*
Attachment
device*
Connec-
tor name*
Major, minor
dev. number
CONSOLE/COM1
PORT1/COM2
DIRECT*
DIRECT*
MOTHERBOARD*
MOTHERBOARD*
port_0
port_1
128,5
128,6
i
To Next Page
Loading...
Need help?
General
