Drives
10
U24802-J-Z146-2-7600 RM400 C Models 119
Dokuschablonen Version 3.2 vom 25.10.93 © Siemens Nixdorf Informationssysteme AG 1993
Druck vom 12. 04.1999 16:17.28 Pfad: H:\Christoph\Manuale\PDF\RM\RM400C Betriebsanleitung\englisch\rm400.k10
10.4 The 4 mm cartridge tape drive
Figure 49: Controls on the 4 mm cartridge tape drive
The ready indicator (1)
– flashes when the self-test is running on the drive after you switch the system
unit on or if the drive is accessed in normal operation.
– is lit if there is a cartridge in the drive.
– is off if there is no cartridge in the drive.
The startup and positioning times for 4 mm tapes are relatively long.
The error indicator (2)
– briefly lights up green after you switch the system unit on. It switches off once
the self-test has been successfully completed.
– flashes amber if the drive is in urgent need of cleaning.
– lights up amber if the drive is malfunctioning.
You must not press the release button
(3) if the ready indicator is lit or is
flashing, as this may cause loss of data.
(1) Ready indicator
(2) Error indicator
(3) Release button
3
1
2
!
To Next Page
Loading...
Need help?
General
