Online replacement (OLR)
6
U24802-J-Z146-2-7600 RM400 C Models 71
Dokuschablonen Version 3.2 vom 25.10.93 © Siemens Nixdorf Informationssysteme AG 1993
Druck vom 12. 04.1999 16:17.18 Pfad: H:\Christoph\Manuale\PDF\RM\RM400C Betriebsanleitung\englisch\rm400.k06
Ê Slide the OLR shuttle into the bay where the defective drive used to be.
Ê Push against the frame of the OLR shuttle (not against the handle!) until the
handle locks into place. The frame is easier to push into place if you slightly lift
the handle.
The new drive must be installed in the same place as the defective drive
used to occupy, as otherwise the automatically allocated address of the
drive will be incorrect.
Once you have replaced the drive, reassemble the peripherals cabinet as described
in its operating instructions.
6.5 Configuring a replacement drive
Once you have installed the replacement drive:
Ê Answer yes to the query Exchanging disk done?.
If you enter no, the installation procedure is aborted.
Once the replacement procedure has been completed, a background process
performs a hardware analysis of the new drive, accompanied by appropriate
messages on your monitor. Then, also in the background, the mirrored drives are
equalized. Depending on the volume of data and the number of drives, it may take
quite a long time (up to an hour) before drive mirroring is fully restored. All files
remain accessible to users throughout the installation period.
If you are operating with a RAID setup, you must use the RAIDmaster Storage Manager
to configure the replacement drive (see the “RAIDmaster - System -Administrator’s
Guide”).
i
To Next Page
Loading...
Need help?
General
