Installing peripherals
5
U24802-J-Z146-2-7600 RM400 C Models 57
Dokuschablonen Version 3.2 vom 25.10.93 © Siemens Nixdorf Informationssysteme AG 1993
Druck vom 12. 04.1999 16:17.14 Pfad: H:\Christoph\Manuale\PDF\RM\RM400C Betriebsanleitung\englisch\rm400.k05
5.1.6 IDC (ISA Diagnostic Controller)
Figure 37: IDC (ISA Diagnostic Controller) (CM01)
5.1.7 Adding peripherals later
If you want to add peripherals at a later date, you must always proceed in the
following order.
Ê Shut down the system (see section “Shutting down the system unit” on page
34).
Ê Press the [ON/OFF] button to switch the system unit off.
Under Reliant UNIX or SINIX V5.42, if you shut down the system with the
shutdown command, the system switches itself off automatically.
Ê Unplug the system unit’s power cord. With the RM400-C80 and C90 models
you must pull out both power connectors.
Ê Make the connections between the system unit and the new peripheral.
Ê Plug in the power cords of the system unit and the peripheral.
To Next Page
Loading...
Need help?
General
