Siemens RM400 C Series - Closing the Peripherals Cabinet

Online replacement (OLR) 6
U24802-J-Z146-2-7600 RM400 C Models 75
Dokuschablonen Version 3.2 vom 25.10.93 © Siemens Nixdorf Informationssysteme AG 1993
Druck vom 12. 04.1999 16:17.19 Pfad: H:\Christoph\Manuale\PDF\RM\RM400C Betriebsanleitung\englisch\rm400.k06
6.7.2 Closing the peripherals cabinet
When you have finished, replace the door or the back cover of the peripherals
cabinet:
Replacing the door on the front of the RM400 BG31/32 peripherals cabinet
Ê Lift the door into the groove at the bottom of the front of the peripherals cabinet
and press it against the cabinet until it latches into place.
Ê Turn the keyswitch on the operator panel of the RM400 BG31/32 peripherals
cabinet to the right, into the vertical position.
The door is now locked.
Replacing the back cover of the RM400 BG31/32 peripherals cabinet
Ê Lift the back cover into its groove at the bottom of the peripherals cabinet and
press it against the cabinet until it latches into place.
Ê Secure the back cover by inserting a T20 Torx screwdriver or a 4 mm slit screw-
driver into the hole in the release button (as shown in the left-hand diagram in
figure 44 on page 74) and turn the screw anti-clockwise until it is tight.