82 RM400 C Models U24802-J-Z146-2-7600
7
Software
Graphical monitor as console
If your console is a graphical monitor, you will be prompted to configure the graphics
features of the hardware you are using. The graphics parameters you can define are
needed for three hardware components:
– keyboard
–mouse
– screen
You will need the following information:
This information can be found on the device labels or in the operating instructions
for the devices.
You enter the information in windows containing separate forms for configuring the
mouse, the keyboard and the terminal.
These windows are part of the SYSADM user interface. For further information on
SYSADM refer to the manual “System Administration and Hardware Configuration
Using the SYSADM User Interface”.
Country-specific keyboard
variant used:
Terminal port used:
Terminal type used:
e.g. German (see ID plate, e.g. DEU)
SVGA port on the motherboard (onboard) or
graphics controller in a PCI slot
33 cm (14"), 35 cm (15"), 40 cm (17"), 50 cm (21")
To Next Page
Loading...
Need help?
General
