Configuration using Web Based Management and Command Line Interface
4.4 The Agent menu
SCALANCE X-300 / X-400
130 Configuration Manual, 10/2014, C79000-G8976-C187-22
Follow the steps below to create a new entry:
1. Click the "New Entry" button on the "Management Access Control List" page.
The "Management ACL Configuration" page appears.
2. Enter the path cost calculation in the first input box.
3. Enter the subnet mask in the second input box.
4. Enter VLANs or VLAN ranges in the third input box.
5. For X414 only:
Enable the "Out-Band Port Enabled" option if you want the IP address to access the
switch via the out-band port.
6. Enable the required ports.
7. Enable the required services.
8. To transfer the changed information to the device, click the "Set Values" button.
9. To return to the "Management Access Control List" overview, click the "Current Entries"
button.
Editing an existing entry
Follow the steps below to modify an existing entry:
1. Click on the IP address of the entry you want to modify on the "Management Access
Control List" page.
2. Make the required modifications.
The entries in the "IP Address" and "Subnet Mask" boxes are read-only.
3. To transfer the changed information to the device, click the "Set Values" button.
4. To return to the "Management Access Control List" overview, click the "Current Entries"
button.
Follow the steps below to delete an existing entry:
1. Click on the IP address of the entry you want to delete on the "Management Access
Control List" page.
The "Management ACL Configuration" page appears.
2. Click the "Delete" button.
the entry is deleted.
To Next Page
Loading...
Need help?
General