Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
169
Figure 4-65 Current Multicast Groups
Information in the filter table
The four areas of the filter table show the following information:
The VLAN-ID assigned to this MAC address.
The MAC address of the node that the IE switch has learned or the user has configured.
Shows the status of each address entry. The following information is possible:
●
The address was entered statically by the user. Static addresses are stored permanently;
in other words, they are not deleted when the aging time expires or when the switch is
restarted.
●
The destination port for this address was obtained by IGMP Configuration.
●
The destination port for this address was registered by a received GMRP frame.
There is a column for each slot. Within a column,
the multicast group to which the port belongs is shown:
●
(Member) Multicast frames are sent via this port.
(in red)
Multicast is configured in a VLAN that is, however, not configured on the relevant port.
Due to the different VLAN-ID, the multicast cannot be forwarded via this port.
●
(Registered) Member of the multicast group, registration was by a GMRP frame.
●
(IGMP) Member of the multicast group, registration was by an IGMP packet.
To Next Page
Loading...
Need help?
General