Siemens SCALANCE X-400 Configuration Manual

Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
SCALANCE X-300 / X-400
Configuration Manual, 10/2014, C79000-G8976-C187-22
227
Rx Power State
●
disabled
FMP is disabled.
●
ok
The value for the received power of the optical link is OK.
●
maintenance required
Check the link.
An event is triggered.
●
maintenance demanded
The link needs to be checked.
An event is triggered and the fault LED is lit yellow.
●
link down
The connection is interrupted.
Rx Power [dBm]
Shows the current value of the received power.
The value can have a tolerance of +/- 3 dB.
Power loss State
To be able to monitor the power loss of the connection, the port requires a link to another
port with FMP enabled.
●
disabled
FMP is disabled.
●
ok
The value for the power loss of the optical link is OK.
●
maintenance required
Check the link.
An event is triggered.
●
maintenance demanded
The link needs to be checked.
An event is triggered and the fault LED is lit yellow.
●
idle
The port has no connection to another port with FMP enabled.
If no diagnostics information has been received for 5 cycles, the connection counts as
being interrupted. A cycle lasts 5 seconds.
Power loss [dB]
Shows the current value of the power loss.
The value can have a tolerance of +/- 3 dB.

Siemens SCALANCE X-400 Specifications

General

Brand	Siemens
Model	SCALANCE X-400
Category	Switch
Language	English