7 Operation at Use of a PC
7.3 Configuration of the Device
120 SENTRON PAC5100/5200, 7KM5212/5412, Device Manual
E50417-H1040-C568-A1, Edition 03.2015
To change the outputs of a binary output, proceed as follows:
✧ In the navigation window, select the Operational menu, then the Process connections submenu and
click Binary outputs.
Figure 7-21 Configure Tab, Binary Outputs Input/Output Window
NOTE
The parameterization of both binary outputs is identical. Figure 7-21 depicts binary output Terminal G1/3 as
output for indications and binary output Terminal G1/2 as energy counter.
You can only set either an indication or
an energy counter for a binary output.
To Next Page
Loading...
