Siemens SIMATIC ET 200SP Function Manual

Product overview
Communication
18 Function Manual, 11/2019, A5E03735815-AH
Interfaces of interface modules
PROFINET and PROFIBUS DP interfaces of the interface modules (IM) in ET 200MP,
ET 200SP and ET 200AL are used to connect the distributed I/O ET 200MP, ET 200SP and
ET 200AL to PROFINET or PROFIBUS of the higher-level IO controller or DP master.
①
PROFINET interface with 2-port switch
Figure 2-5 PROFINET interfaces IM 155-5 PN ST (ET 200MP), IM 155-6 PN ST (ET 200SP), and
IM 157-1 PN (ET 200AL)
Communications services
The communications services described below use the interfaces and communication
mechanisms provided by the system via CPUs, communication modules and processors.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C