Siemens SIMATIC ET 200SP Function Manual

Communication
60 Function Manual, 11/2019, A5E03735815-AH
PG communication
4
Properties
Using PG communication, the CPU or another module capable of communication exchanges
data with an engineering station (for example PG, PC). The data exchange is possible via
PROFIBUS and PROFINET subnets. The gateway between S7 subnets is also supported.
PG communication provides functions needed to load programs and configuration data, run
tests, and evaluate diagnostic information. These functions are integrated in the operating
system of the module capable of communication.
Requirements
● The PG/PC is physically connected to the communication-capable module.
● If the communication-capable module is to be reached via S7 routing, the hardware
configuration has to be loaded in the participating stations (S7 router and end point).
Procedure for connecting online
You must establish an online connection to the CPU for the programming device
communication:
1. Select the CPU in the project tree in STEP 7.
2. Select the "Online > Go online" menu command.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C