Siemens SIMATIC ET 200SP Function Manual

PG communication
Communication
Function Manual, 11/2019, A5E03735815-AH
61
3. In the "Go online" dialog, make the following settings for your online connection:
– Select interface type (e.g. PN/IE) in the "Type of PG/PC interface" drop-down list.
– In the "PG/PC interface" drop-down list, select the PG/PC interface (e.g. Ind. Ethernet
card) you want to use to establish the online connection.
– Select the interface or the S7 subnet with which the programming device/PC is
physically connected from the "Connection to interface/subnet" drop-down list.
– If the communication-capable module can be reached via an S7 router (gateway),
select the S7 router that connects the subnets in question from the "1st gateway"
drop-down list.
Figure 4-1 Setting up PG communication

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C