Siemens SIMATIC ET 200SP Function Manual

Communications services
3.4 Setting up a connection
Communication
28 Function Manual, 11/2019, A5E03735815-AH
Setting up a programmed connection
You set up the programmed connection in the program editor of STEP 7 in the context of a
CPU by assigning instructions for communication, for example TSEND_C.
When specifying the connection parameters (in the Inspector window, in the properties of the
instruction), you are supported by the easy-to-use user interface.
Figure 3-1 Programmed setup

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C