Siemens SIMATIC ET 200SP Function Manual

Communication with the redundant system S7-1500R/H
13.6 Open User Communication with the redundant system S7-1500R/H
Communication
Function Manual, 11/2019, A5E03735815-AH
341
Setting up a connection via a device IP address
To set up an OUC-connection via a device IP address of one of the two CPUs:
● Select a suitable PROFINET interface of the S7-1500R/H redundant system.
● Deselect the "Use address of H-system" check box.
Figure 13-14 OUC-connection via a device IP address
Reference
You can find additional information on system states in the S7-1500R/H
(https://support.industry.siemens.com/cs/ww/en/view/109754833
) system manual.
See also
PROFINET FUNCTION MANUAL
(https://support.industry.siemens.com/cs/ww/en/view/49948856
)

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C