Using RemoteOperate Client
7.1 Creating/editing a server selection list
Mobile Panel 277 RO
108 Operating Instructions, 10/2015, A5E36824256-AA
Note
Limited number of servers per client
RemoteOperate supports a maximum of ten servers in a client's server sel
ection list.
If you wish to create a new server, make sure that there are no more than nine servers in the
server selection list.
Proceed as follows:
1. With the button, open the dialog box to create a server:
2. In the "tree path" box, enter the path of the server within the server selection list. "Path"
denotes the node in the server tree under which the server is created. For example, if you
specify "\Area1\", the IP address of the server will subsequently appear under the "Area1"
node:
To Next Page
Loading...
