Using RemoteOperate Client
7.1 Creating/editing a server selection list
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
109
Note
The path of the server selection list has a maximum of three levels. Specify no more than
three path levels for a server, for example
"\Area2\Segment1\Place2\".
If the path already exists in the server selection list, the new server will be inserted at this
point. If the path does not yet exist, it is created automatically.
3. Enter the IP address of the new server in the "IP address:" input box.
4. Enter a description of the new server in the "comment:" input box. This comment is
displayed next to the IP address in the tree of the server selection list.
5. Confirm your settings with .
Changing the properties of a server
Proceed as follows:
1. Select the server whose properties you wish to edit.
2. With the button, open the dialog box to change the server properties.
3. Follow steps 2 to 5 of the instructions for creating a new server.
Proceed as follows:
1. Select the server that you wish to remove from the server selection list.
2. Remove the selected server from the server selection list using the button.
You have created a new server selection list or changed an existing server selection list.
To Next Page
Loading...
