Expanding and assigning parameters to the device
6.6 Drives
SIMATIC IPC847E
Operating Instructions, 10/2018, A5E43920357-AA
107
Installing a 5.25" adapter module for removable trays
You can find information on the correct mounting location for this adapter module can be
found in "Permissible expansion for temperature range 0 to 40 °C (Page 100)" and
"Permissible expansion for temperature range 0 to 50 °C (Page 102)".
● The device is equipped with the drive cage type A.
● There is no drive or any other component in the mounting location for 5.25" components.
● An original spare part, that is a 5.25" adapter module approved for this device, see notes
in "Hardware accessories (Page 30)".
● The device is fully disconnected from the line voltage, see "Switching off the device
(Page 60)".
● The device is open, see important information in "Open the device (Page 89)".
1. Unlock the drive mounting bar together with the blanking plate by pressing laterally
against the surfaces
① and push the drive mounting bar forward from the device in the
direction of the arrow.
2. Remove the blanking plate.
To Next Page
Loading...
Need help?
General
