Siemens SIMATIC IPC847E - Removing and Installing Hardware

Device maintenance and repair
7.3 Removing and installing hardware
SIMATIC IPC847E
130 Operating Instructions, 10/2018, A5E43920357-AA
7.3
Removing and installing hardware
7.3.1
Changing the filter pad
Requirement
● The device is fully disconnected from the line voltage, see "Switching off the device
(Page 60)".
● The fan cover has been removed; see "Remove the fan cover (Page 131)".
● An original spare part, i.e. a filter pad of the same type.
Procedure
1. Remove the filter pad from the fan cover.
2. Insert the new filter pad into the fan cover. It is inserted loosely in the fan cover. When
you insert the filter pad, make sure it lies evenly in the fan cover.
3. Replace the fan cover.
See also
Maintenance intervals (Page 129)