Siemens SIMATIC IPC847E User Manual

Technical support
B.2 Troubleshooting
SIMATIC IPC847E
198 Operating Instructions, 10/2018, A5E43920357-AA
B.2.2
Problems when booting the device
Problem
Cause
Remedy
After changing the hard disk,
the system does not boot from
the RAID system
RAID system does not have high-
est boot priority
Change the boot priority in the firmware (BIOS) un-
der "Boot > Boot device".
• Permit RAID system in the boot priority
• Give RAID system top boot priority
After changing the hard disk,
"Unused" is indicated for the
relevant SATA port.
System was booted without func-
tioning drive. The removable tray
might not be fully pushed in.
Reboot the system with a functioning hard disk.
Computer does not boot or
"Boot device not found" is
displayed.
The boot medium is not approved Set the boot priority to "Enabled" in the firmware
(BIOS) under "Boot > Boot device".
The boot device is not in first place
of the boot priority in the BIOS
setup
Change the boot priority in the firmware (BIOS) un-
der "Boot > Boot device".
The boot data storage medium is
set up with GPT, and UEFI boot is
deactivated in the firmware (BIOS)
Activate UEFI mode in the firmware (BIOS).
The startup of a Windows
operating system located on a
GPT data storage medium is
aborted with the following
error message:
"Status: 0xc0000225 Info: The
boot selection failed because
a required device is inacces-
sible"
The settings in the boot loader file
"BCD" are incorrect or damaged.
Restore the Windows® operating system.
You can find the files and descriptions needed for
this on the supplied data storage medium.

Siemens SIMATIC IPC847E Specifications

General

Brand	Siemens
Model	SIMATIC IPC847E
Category	Industrial PC
Language	English