Operating the device
5.4 Operating RAID systems
SIMATIC IPC847E
68 Operating Instructions, 10/2018, A5E43920357-AA
Operating onboard RAID system
5.4.4.1
Configuring the onboard RAID system
If you ordered a device with an onboard RAID system, the onboard RAID system is pre-
configured by default.
If you subsequently set up an onboard RAID system, you still have to configure it.
● The drives required for the onboard RAID system are installed in the device, see:
– RAID1 system: Installation options for drives (Page 67)
– RAID5 system: Installation options for drives (Page 67)
Navigation in the firmware of the onboard RAID system
• Select entry (then confirm selection) • Arrow keys on the keyboard
• Confirm selection • <Return> key
• Back to previous window • <Esc> key
Setting up an onboard RAID system (Create Volume)
1. Switch on the device or restart the device.
2. After starting the device, immediately press the <Esc> key and keep it pressed as soon
as the message "
Press ESC for boot options" appears.
3. Use the arrow keys of the keyboard to select "Device Management" from the firmware
selection menu and confirm your selection.
4. Select the entry "Intel <R> Rapid Storage Technology" from the "Devices List".
5. Select "Create RAID Volume".
6. In the next window, enter a name for the RAID system.
7. Select "RAID Level" and select "RAID1" or "RAID5" in the following selection window,
depending on which RAID system you want to set up.
A list of available drives is displayed.
To Next Page
Loading...
Need help?
General
