Furthermore, you can enter comments and activate scheduling for the service monitoring,
measuring circuit test, and calibration.
"Measuring circuit identification data" area
Field Explanations/operating instructions
Plant You can assign the plant name in this text box.
Process tag Shows the name of the process tag
Device type Shows the device type
Manufacturer Shows the manufacturer of the field device
Article number Shows the article number of the device
EDD revision Identifier for an EDD revision
Type ID Identifier for a device type in hexadecimal format.
You can find information on this in IEC 61804-3.
Device revision Identifier for a device revision
"Test details" area
Field/Area Explanations/operating instructions
Tester You can assign the name of the tester in this text box.
Date of test Shows the date of the test
Test medium
Comment Enter a comment.
"Scheduling" area
Field Explanations/operating instructions
"Service" check box If this check box is selected, you can enter a time for the next service
in the text box.
The time is monitored. When the time is reached or exceeded, the
diagnostic status of the instance is set to "Maintenance demanded".
"Measuring circuit test" check box If the check box is selected, you can enter a time for the next
measuring circuit test in the text box.
The time is monitored and when it is reached or exceeded, the
diagnostic status of the instance is set to "Maintenance required".
"Calibration" check box If the check box is selected, you can enter a time for the next
calibration in the text box.
The time is monitored and when it is reached or exceeded, the
diagnostic status of the instance is set to "Maintenance required".
Menus and dialog boxes in SIMATIC PDM
8.3 "Device" menu
Help for SIMATIC PDM (V8.2)
180 Operating Manual, 02/2014, A5E33203676-AA
To Next Page
Loading...
