Siemens SIMATIC TD 200 - Page 35

2-13
SIMATIC TD 200 Operator Interface
C79000-G7076-C272-01
For this example, make the selections shown in Figure 2-10 and click “OK.”
Embedded Data
Cancel
OK
Delete
None
Word
Double Word
Signed
Unsigned
1
Digits to the right of the
decimal
User must acknowledge message
User is allowed to edit this data.
VW98Address of Data Value:
Data Format: Display Format:
Figure 2-10 TD 200 Message: Creating a Word Embedded Data
Figure 2-11 shows the message dialog box after you have formatted the first
embedded data value. The grayed fields show the characters used by the format
information (always two) and the data value (two for word values).
The second data value in the message is a real number. Real numbers require four
characters plus two characters for format information. Move the cursor to position
35 and click on “Embedded Data...” to enter the format information for the second
data value.
TD 200 Configuration Wizard
Cancel
Finish
You have asked to configure 3 message(s). Define your message by
placing your highest priority message first.
< Prev
Embedded Data...
INS
<Previous Message Next Message >
VB80
V14.6
Message beginning address:
Message enabled bit:
10 15 20
PREV . SETPOINT :
30 35 40
NEW SETPOI NT :
25
Note: Grayed fields
are place holders for
embedded data
values.
TD200
Message 2 of 3
5
Figure 2-11 Wizard: Embedded Data Value Place Holder in Message
Confi
g
urin
g
the TD 200