Siemens SIMATIC TD 200 - Creating a Sample Program

2-19
SIMATIC TD 200 Operator Interface
C79000-G7076-C272-01
2.2 Creating a Sample Program
Click on the Ladder Editor to create and view your program in Ladder Logic. Click
on the Statement List Editor to create and view your program in Statement List
format. Figure 2-18 shows a sample program in both the Ladder and Statement
List editors. This program uses the TD 200 configuration information from the
example created in this chapter.
Download the program and data block to a CPU. Attach a TD 200 to the CPU to
see the messages created with the wizard. Use the following keys on the TD 200:
 Press F1 to go to the setpoint message.
 Press ENTER to edit the setpoint. Press ENTER again to go to the
acknowledge message.
 Press ENTER to acknowledge the third message.
 Press F2 to enable all three messages at once.
 Press F3 to disable all the messages.
Confi
g
urin
g
the TD 200