Siemens SIMATIC TD 200 User Manual

3-10
SIMATIC TD 200 Operator Interface
C79000-G7076-C272-01
Entering a Password
To enter a password, perform the following steps.
Key Action Display
1. The TD 200 scrolls through the
possible characters for the password.
PASSWORD ********
PASSWORD REQUIRED
2.
ENTER
Press ENTER when the correct
character is found for the current
password character location. The
cursor then moves to the next
character location.
PASSWORD ********
PASSWORD REQUIRED
Repeat this process for all eight password characters. For passwords with fewer
than eight characters, use blank spaces (the default character) by pressing
ENTER for the unused (remaining) characters. After the eighth character is
entered, the TD 200 attempts to legitimize the communication link to the CPU. If
the password is incorrect, the TD 200 displays the message shown in Figure 3-3.
SIEMENS
TD 200
F1
F5
F2
F6
F3
F7
F4
F8
SHIFT ESC
ENTER
Figure 3-3 Incorrect Password Display
Correcting a Password
Press ESC and repeat the steps for entering a password.
Operatin
g
the TD 200

Siemens SIMATIC TD 200 Specifications

General

Brand	Siemens
Model	SIMATIC TD 200
Category	Recording Equipment
Language	English