Siemens SIMOTION ADI4 - Function Parameters

Parameter assignment
3.5 Function parameters
SIMOTION ADI4 - Analog Drive Interface for 4 Axes
Manual, 05/2009, 6FC5 297-0BA01-0BP6
43
3.5 Function parameters
Parameters
All function-specific parameters of the ADI4 DP slave are set in the "Encoder" tab:
● Encoder type
● Unipolar spindle (or unipolar motor)
● Shutdown ramp
● Shutdown delay
● Tolerable sign-of-life failures
● Reserved bits for fine resolution
● 611U conformant mode
The figure shows the corresponding dialog box with sample values for the various encoder
types and parameters.
77/ 77/ 66, 66,
%LQDU\*UD\
N%LWV N%LWV
  





'3VODYHSURSHUWLHV
*HQHUDO (QFRGHU
(QFRGHUB
VW$[LV QG$[LV UG$[LV WK$[LV
(QFRGHUW\SH (QFRGHUW\SH (QFRGHUW\SH
3DULW\ 3DULW\
5HVROXWLRQ
8QLSRODUVSLQGOH
6KXWGRZQGHOD\>V@
6KXWGRZQUDPS>PV@
5HVHUYHGELWVIRUILQHUHVROXWLRQ
7ROHUDEOHVLJQRIOLIHHUURUV
8FRQIRUPDQWPRGH
&DQFHO2. +HOS
5HVROXWLRQ 5HVROXWLRQ 5HVROXWLRQ
0VJ/HQJWK 0VJ/HQJWK
(QFRGLQJ (QFRGLQJ
%DXGUDWH %DXGUDWH
(QFRGHUW\SH
(QFRGHUB (QFRGHUB (QFRGHUB
&RQILJXUDWLRQ ,VRFKURQRXVRSHUDWLRQ
Figure 3-3 "DP Slave Properties" dialog box, "Encoder" tab