Siemens SIMOTION ADI4 - Equidistant Master Cyclic Component TDX

Parameter assignment
3.6 Parameter assignment of the DP communication
SIMOTION ADI4 - Analog Drive Interface for 4 Axes
56 Manual, 05/2009, 6FC5 297-0BA01-0BP6
Dialog: Start
Dialog: DP slave properties
Tab: Isochronous operation
Radio button: Synchronize drive to equidistant DP cycle ☑
Button: Alignment
 












+HOS&DQFHO2.
$OLJQPHQW
*HQHUDO &RQILJXUDWLRQ ,VRFKURQRXVRSHUDWLRQ
'3VODYHSURSHUWLHV
1HWZRUNVHWWLQJVLQPV
(TXLGLVWDQWEXVF\FOHDFWLYDWHG
(TXLGLVWDQW'3F\FOH (TXLGLVWDQWPDVWHUF\FOLFFRPSRQHQW
)DFWRU
0DVWHUDSSOLFDWLRQF\FOH
>PV@
7LPH7R>PV@
6HWSRLQWDFFHSWDQFH
7LPH7L>PV@
$FWXDOYDOXHDFTXLVLWLRQ
'3F\FOH>PV@
)DFWRU
)DFWRU
)DFWRU
%DVHWLPH>PV@
%DVHWLPH>PV@
%DVHWLPH>PV@
%DVHWLPH>PV@
6\QFKURQL]HGULYHWRHTXLGLVWDQW'3F\FOH
[
[
[
[
Figure 3-8 "DP Slave Properties" dialog box
3.6.3 Equidistant master cyclic component TDX
Procedure
Once synchronization to the equidistant DP cycle has been enabled for all DP slaves, the
time required for the cyclic component of the DP communication must be recalculated.
The calculation is performed automatically by the DP master each time the equidistant bus
cycle is enabled. This is performed in the following dialog box by selecting/clearing the
"Activate equidistant bus cycle" check box.