Siemens SIMOTION ADI4 - Alignment

Parameter assignment
3.6 Parameter assignment of the DP communication
SIMOTION ADI4 - Analog Drive Interface for 4 Axes
Manual, 05/2009, 6FC5 297-0BA01-0BP6
67
3.6.9 Alignment
Procedure
The alignment is used to transfer the values of the current ADI4 DP slave displayed in the
"Isochronous operation" tab to all the other ADI4 DP slaves of the configuration.
Dialog: End
Dialog: DP slave properties
Tab: Isochronous operation
Button: Alignment
OK
+HOS&DQFHO2.
$OLJQPHQW
*HQHUDO &RQILJXUDWLRQ ,VRFKURQRXVRSHUDWLRQ
'3VODYHSURSHUWLHV
1HWZRUNVHWWLQJVLQPV
(TXLGLVWDQWEXVF\FOHDFWLYDWHG
(TXLGLVWDQW'3F\FOH (TXLGLVWDQWPDVWHUF\FOLFFRPSRQHQW
)DFWRU
0DVWHUDSSOLFDWLRQF\FOH
>PV@
7LPH7R>PV@
6HWSRLQWDFFHSWDQFH
7LPH7L>PV@
$FWXDOYDOXHDFTXLVLWLRQ
'3F\FOH>PV@
)DFWRU
)DFWRU
)DFWRU
%DVHWLPH>PV@
%DVHWLPH>PV@
%DVHWLPH>PV@
%DVHWLPH>PV@
6\QFKURQL]HGULYHWRHTXLGLVWDQW'3F\FOH
 












[
[
[
[
Figure 3-16 "DP Slave Properties" dialog box