Commissioning
8.11 Information pertaining to component replacements
Safety Integrated
238 Function Manual, 05/2010, A5E03264275A
5. Carry out a POWER ON (power off/on) for all components.
Note
In this case, the system will not notify you with a flashing LED that a POWER ON is
required.
6. Carry out an acceptance text and acceptance report according to Chapter "Acceptance
test and acceptance report" and table "Effect of the acceptance test for certain
measures".
WARNING
Before re-entering the danger area and before resuming operation, a (partial) acceptance
test must be carried out for all the drives affected by the component exchange (see the
"Acceptance test and acceptance report" chapter).
To Next Page
Loading...
