Commissioning
5.3 Procedure for commissioning via STARTER
Drive converter cabinet units
148 Operating Instructions, 07/07, A5E00288214A
The following command and setpoint source options are available:
PROFIdrive
TM31 terminals
NAMUR
Command sources:
PROFIdrive NAMUR
PROFIdrive
TM31 terminals
Motorized potentiometer
Setpoint sources:
Fixed setpoint
Note
With SINAMICS S150, only CDS0 is normally used as a default setting for the command and
setpoint sources.
Make sure that the selected default setting is compatible with the actual system
configuration.
You cannot retrospectively change the selected default setting with
< Back (unless the current value is No selection).
If you made an incorrect entry, delete the complete drive unit from the project navigator and
create a new one.
34. Check your default selections carefully and then click Continue >
To Next Page
Loading...
