Operation
6.7 Control via the operator panel
Drive converter cabinet units
228 Operating Instructions, 07/07, A5E00288214A
TM31 object
Table 6-22 List of signals for the operation screen – TM31 object
Signal Parameters Short name Unit Scaling
(100 % = ...)
Analog input 0 [V, mA] r4052[0] AI_UI V, mA V: 100 V / mA: 100 mA
Analog input 1 [V, mA] r4052[1] AI_UI V, mA V: 100 V / mA: 100 mA
Analog input 0, scaled r4055[0] AI_% % V: 100 V / mA: 100 mA
Analog input 1, scaled r4055[1] AI_% % V: 100 V / mA: 100 mA
Setting the date/time (for date stamping of error messages)
In this menu, you set the date and time.
You can also set whether and/or how the AOP and drive unit are to be synchronized.
Synchronization of the AOP with the drive enables error messages to be date- and time-
stamped.
● None (factory setting)
The times for the AOP and drive unit are not synchronized.
● AOP -> Drive
– If you activate this option, the AOP and drive unit are synchronized immediately
whereby the current AOP time is transferred to the drive unit.
– The current AOP time is transferred to the drive unit every time the AOP is started.
– At 02:00 (AOP time) every day, the current AOP time is transferred to the drive unit.
● Drive -> AOP
– If you activate this option, the AOP and drive unit are synchronized immediately
whereby the current drive unit time is transferred to the AOP.
– The current drive unit time is transferred to the AOP every time the AOP is started.
– At 02:00 (AOP time) every day, the current drive unit time is transferred to the AOP.
Date format
In this menu, the date format can be set:
● DD.MM.YYYY: European date format
● MM/DD/YYYY: North American data format
To Next Page
Loading...
