Siemens SINUMERIK 802D

SINUMERIK 802D sl Operating and Service Training Manual Page 1
C72
C72
Milling tool and workplanes
C72
1 Brief description
Module objective:
Upon completion of this
module you can define new tools and also parameterise them.
Module description:
A descriptio
n of the tools which are supported by the controller and also how they are parameterised
can be foun
d in this module.
Module content:
• Tool geometry and workplanes
• New milling tool
• Tool setting on the machine
• Drilling tools
New milling tool
Tool setting on the ma-
chine
Section 3
Section 4
Tool geometry and
workplanes
Section 2
Drilling Tools
Section 5