Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 2
C72
C72
Section 2
Work plane for milling.
When working on a milli
ng machine with milling tools, the work plane is
determined from the
X-axis (=1st. axis in plane) and the Y-axis (=2nd. axis
in plane).
The Z axis is the infeed
axis and is perpendicular to the plane X/Y plane.
Therefore the following i
s the workplane which is active on a milling machi-
ne.
To activate this, in the p
art program G17 has to be programmed.
The G18 or G19 plane can be select
ed when a spindle attachment (rotary
head etc.) is used which
places the orientation of the spindle into the X or
Y axis.
Tool geometry and workplanes
2.1 Tool geometry and workplanes
To Next Page
Loading...
