Siemens SINUMERIK 802D

Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 4
C97
C97
Section 3
Miscellaneous functions
3.1 Miscellaneous functions
The miscellaneous functions M initia
tes switching operations, such as
“coolant ON/OFF” and other function
s.
Various M functions have already b
een assigned to the CNC control, M
functions not already assigned to the CNC contr
ol are reserved for free
assignment
by the machine tool manufacturer.
Program stop (M00, M01)
Function
When place
d between axis movements, this command will stop the
NC program until the cycle start butto
n is pressed again.
Programming
M00
; unconditional stop (you must press cycle start)
M01
; conditional stop
(softkey in Auto page “program control”)
————
—————————————————————————————
softkey “program control”
will allow you to select
softkey “Condit. stop” to
activate and deactivate M01
M01 is conditional, can be activated or deactivated in the “AUTO” page,
under softke
y “program control” Then pressing softkey “Condit stop”