Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 3
C41
C41
Section 3
Setting password
In order to make changes to the NC machine data, the corresponding
password must be set.
Certain machine data can only be changed with the
SERVI
CE or MANUFACTURER password, in this case, contact the builder
of the machine.
The followin
g sequence shows graphically how to change/activate the
password.
Enter new
password
level
Change stan-
dard passw
ord
Password cancelled
Keyswitch active
Section 4
Changing machine data + data save
When the necessary password is activated the machine data can be
changed.
Machine data’s are each
having an activation criteria, this criteria deter-
mines when the new ma
chine data value will become active. This criteria
is written in t
he machine data list next to the respective data.
Po
= after powering on
Re
= after pressing Reset key on machine control panel
Cf
= after powering on
Im
= immediately
After makin
g changes to the machine data, it is important to make a
new backu
p see hand book module’s C19 and C17
3.1 Setting
password
4.1 Changing machine data + data save
To Next Page
Loading...
Need help?
General
