Siemens SINUMERIK 802D Training Manual

Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 6
C72
C72
Using vertical softkeys the respective lengths will be automatically calcula-
ted and entered in to the control.
You have to select the mode (length or diameter) first with the respective
softkeys.
Measuring mode selection: 0r
With set length or set diameter the measuring is completed.
or
The value calculated can then be checked in the Offset/param area.
Section 4
Tool setting on the machine

Siemens SINUMERIK 802D Specifications

General

Brand	Siemens
Model	SINUMERIK 802D
Category	Control Unit
Language	English