Siemens SINUMERIK 802D

Notes
SINUMERIK 802D sl Operating and Service Training Manual Page 2
C95
C95
Section 2
Introduction to ISO Dialect
2.1 Introduction to ISO Dialect
Siemens Mode
The followin
g conditions apply when Siemens mode is active:
• Siemens G functions are interpreted on the control by default.
• It is not possible to extend the Siemens programming system
with ISO Dia
lect functions because some of the G functions
have different meanings.
ISO Dialect
mode
The following conditions apply when ISO Dialect mode is active:
• Only ISO dialect G codes can be programmed, not Siemens G
functions.
• It is not possible to use a mixture of ISO Dialect code and Sie-
mens code in the same NC block.
• If further Siemens functions are to be used, it will be necessary
to switch to
Siemens mode first.