Siemens SINUMERIK 802D

SINUMERIK 802D sl Operating and Service Training Manual Page 1
C8
C8
Pushbutton Tests
C8
1 Brief description
Module description:
There are two possibilities currently
existing to
connect a Machine control panel to the 802D SL CNC.
1.
The first variant is to connect an MCP to the (additionally required) MCPA board, section 2.1.
2.
The second variant is to connect the MCP to the PLC periphery, section 2.2
The hardware differs bet
ween the two variants, the
part numbers (MLFB) are given in the respective
sections
.
In certain ca
ses it may become necessary to perform a pushbutton test. The objective of the test, is
to determine whether or not a pushb
utton / LED on the machine control is defect.
Module objective:
Upon completion of this
module you can identify whic
h Machine Control Panel (MCP) i
s installed and
perform a pushbutton te
st
Module content:
• Hardware identification
• Hardware interface
Hardware interface
Section 3
Hardware identification
Section 2