SINUMERIK 802D sl Operating and Service Training Manual Page 1
C1
C1
RCS802 Data Transfer Tool
C1
1 Brief description
Module objective:
Upon completion of this
module you can use the RCS802 Data transfer tool to transfer data to/from
the control.
Module description:
NC programs can be written internally (Direct to the NC me
mory) or externally (computer / laptop).
The programs which are created ca
n be transferred using the RCS802 tool to/from the control.
Module content:
• Principle of operation
• Transfer data from the controller
• Transfer data to the controller
Transfer data from the
controller
Section 3
Transfer data to the
controller
Section 4
Principle of operation
Section 2
To Next Page
Loading...
