To Next Page

To Previous Page

General Functions 08.02

9.2 Teach In

9-164 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition

Teach

Additional notes

You can accept the movements directly by pressing either the key

"Teach RT (rapid traverse)" or the key "Teach F (feedrate)" on the

machine control panel.

Please follow the advice of the machine manufacturer.

Slide movements in

MANUAL mode

using the control stick

Select MANUAL mode.

Select the direction (straight or conical) with the control stick.

Start the movement by pressing the "NC Start" key.

You can stop the movement by pressing the "NC Stop" key or by

returning the control stick to the center position. The movement is

stored automatically.

Programmed spindle speed values and feedrates are multiplied by the

percentage of the override switch in question at the end of a

movement and transferred to the EasyStep program.

You cannot execute the following functions when Teach In is active.

• Zero offset

• Preset

• Enter tool offset data

• Measure tool.

Siemens SINUMERIK 810D Operation & Programming Manual

Other manuals for Siemens SINUMERIK 810D