Siemens SINUMERIK 810D

5
08.02 Turning with Cycles
5
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 5-79
Turning with Cycles
5.1 General notes............................................................................................................ 5-80
5.2 Turning cycles in CYCLE mode ................................................................................ 5-81
5.2.1 Thread cutting ........................................................................................................... 5-81
5.2.2 Controlling thread cutting operations ........................................................................ 5-87
5.2.3 Re-working a thread.................................................................................................. 5-88
5.2.4 Undercuts Form E and F........................................................................................... 5-89
5.2.5 Thread undercuts ...................................................................................................... 5-91
5.2.6 Drilling in longitudinal axis (center)............................................................................ 5-93
5.2.7 Hole circle drilling ...................................................................................................... 5-97
5.3 Stock removal/grooving cycles in STOCK REMOVAL mode.................................. 5-100
5.3.1 Stock removal cycles .............................................................................................. 5-100
5.3.2 Grooving cycles....................................................................................................... 5-105