Siemens SINUMERIK 810D

3
08.02 Preparatory Functions for Machining
3
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 3-41
Preparatory Functions for Machining
3.1 Approach reference points ........................................................................................ 3-42
3.2 Setup......................................................................................................................... 3-44
3.3 Incremental feed mode ............................................................................................. 3-45
3.4 Offsets....................................................................................................................... 3-47
3.4.1 General notes............................................................................................................ 3-47
3.4.2 Preset........................................................................................................................ 3-48
3.4.3 Manual offset............................................................................................................. 3-49
3.4.4 Delete manual offset ................................................................................................. 3-50
3.4.5 Zero offset ................................................................................................................. 3-51
3.5 Spindle speed limitation ............................................................................................ 3-52
3.6 Oriented spindle stop ................................................................................................ 3-53
3.7 C axis mode .............................................................................................................. 3-54
3.8 Tool ........................................................................................................................... 3-55
3.8.1 Enter tool offset data ................................................................................................. 3-55
3.8.2 Selecting/deselecting tool offset................................................................................ 3-57
3.8.3 Measure tool ............................................................................................................. 3-58
3.8.4 Tool wear compensation ........................................................................................... 3-60
3.9 Measuring system changeover inch/metric............................................................... 3-61