3
Preparatory Functions for Machining 08.02
3.4 Offsets
3
© Siemens AG, 2002. All rights reserved
3-50 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
3.4.4 Delete manual offset
Sequence of operations
Select any operating mode
Select the extended soft key menu by pressing the ">" key
Offset
Select the soft key labeled "Offset" in the soft key menu.
All position data are then displayed on the screen.
Delete
man. offs.
Select soft key labeled "Delete man. offs."
The function is not executed.
or
The function is executed.
Offset can be deleted if no Start command has been given.