cles
11
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition 11-173
Alarm number Alarm text Cycle Explanation, Remedy
61606 "Error during contour
preparation"
Cutting in
STOCK
REMOVAL
During preparation of the contour an
error was detected, this alarm is always
output with NCK alarm 10930 ... 10934,
15800 or 15810 (see Diagnostics
Guide)
62200 "Start spindle" Thread The spindle must be running before the
thread can be machined.
11.1.3 Messages in cycles
The cycles output messages in the dialog line of the control. These
messages do not interrupt processing.
Messages provide you with information about cycle behavior and
processing progress. They are usually retained over a processing
section or until the end of the cycle, e.g. messages about the current
thread during machining as a longitudinal or face thread.