Siemens SINUMERIK 810D

10
Intervention in the Machining Process 08.02
10.1 Abortin
g
a machinin
g
o
p
eration
10
© Siemens AG, 2002. All rights reserved
10-168 SINUMERIK 840D/810D Operator's Guide ManualTurn (BAM) – 08.02 Edition
10.1 Aborting a machining operation
You can cancel a machining operation that has already started in:
MANUAL – Straight mode
with the "NC stop" key
or
MANUAL – Conical mode
with the control stick in the OFF position (center position).
Operating modes with automatic motion switch-off (not MANUAL
mode)
Interrupt movement with the "NC stop" key
The start and stop lamps light up
When you press the "NC stop" key again the soft key menu containing
the soft key "Abort" is displayed (for a limited time).
Start is reset when you press the "Abort" soft key.
The start and stop lamps go out.